SHOWTEC Scanmaster 2 MKII Betriebsanweisung PDF herunterladen (Seite 11)

Scene Playback

There are 3 ways to start scene playback: manual trigger, auto trigger or audio trigger.

1. Manual trigger

1) When the power is turned on, the unit automatically enters Manual mode, and all channel outputs are in

black-out state (the Blackout LED flashes in the display window).

2) Tap the BLACKOUT button (20) to enable the channel output. Blackout LED goes out.

3) Select your desired scene to be replayed, tap this SCENE button (2) to enable the scene (Tap this

SCENE button (2) again to disable the scene).

2. Auto trigger

1) Tap the AUTO/Del button (18), the Auto Trigger LED will light up in the display window, indicating you are

now in the Auto trigger mode.

2) Tap BANK Up/Down button (11) to select the desired bank (0-30).

3) You can use the SPEED fader 5 (or TAP/Disp button 19) and the FADE TIME fader (6) to adjust the

running state.

4) Tap the AUTO/Del button (18) to exit from the Auto mode. Auto Trigger LED goes out.

Note: You can tap the TAP/Disp button (19) twice to create an interval running rate.

3. Audio trigger

1) Tap the MUSIC/Bkc button (16). The Audio Trigger LED will light up in the display window, indicating you

are now in the Audio trigger mode.

2) Tap BANK Up/Down button (11) to select the desired bank (the scenes in the bank will run sensitively by

the Audio signal through the built-in microphone).

3) Tap the MUSIC/Bkc button (16) to exit from the Audio mode. Audio Trigger LED goes out.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Keine Kommentare

SHOWTEC Scanmaster 2 MKII Betriebsanweisung Seite 11